Home Amp/Preamp Asylum

Looking for a new Amp or Preamp? If you're after tubes, post over here.

RE: Clean tube pins and sockets...

Thanks Jonesy. I am certainly not an electonics expert but I dont think a bad tube on either side would cause hum in both. I have cleaned the pins and sockets and the 6v6 are new. The 6922's are ElectroHarmonix and the were in the unit when I purchased it. I was told they had about 100 hours on them. I have two other sets of 6922's and it doesnt really change when I swap them out.


This post is made possible by the generous support of people like you and our sponsors:
  Atma-Sphere Music Systems, Inc.  


Follow Ups Full Thread
Follow Ups
  • RE: Clean tube pins and sockets... - Try1256 15:53:10 02/16/17 (0)

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.