Home Vintage Asylum

Classic gear from yesteryear; vintage audio standing the test of time.

RE: "even though the boards are not quite the same as Dave's design"

You never said which ebay seller you bought your boards from, but in doing a search, I found the ebay seller linked below. Is that where you got yours?

If so, you're right, they do differ from Gellespie's circuit. I only count 9 resistors on the ebay board (same as a stock SCA-35), while Dave's board contains 10 (eleven, if you count the 10K which goes between V-8 pin #2 and eyelet #8, which he adds underneath). Also, I only see the stock Dynaco circuit 12pF cap, no additional (C1) 18pF, as on Dave's board.

If it were me and I had already purchased the stuffed ebay boards, I'd try and shoehorn in the 18pF @500V C1 cap and R38 100k 0.5W resistor missing from the Chinese (i.e. otherwise stock) circuit, as well as using the 10K 0.5W Dave recommends.

Also note that Dave has increased the value of C18, which was 0.1uF @ 250V on the stock board to 1uF @ 250V in his circuit.

Good luck with your project.


"Suddenly, I'm not half the man I used to be. 'Cause now I'm an amputee" J. Lennon


This post is made possible by the generous support of people like you and our sponsors:
  Take Five Audio  


Follow Ups Full Thread
Follow Ups

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.