Home Vintage Asylum

Classic gear from yesteryear; vintage audio standing the test of time.

RE: biasing setup on Scott 222D question

Just put a 10 ohm resistor to ground on each cathode.Then,you simply adjust for 0vdc between each pair of tube's cathodes with the DC balance pot.Then you adjust your bias to the current you want.I think the 7189s are 28ma to 30ma depending on your B+.

"For every complex problem there is an answer that is clear, simple, and wrong" H. L. Mencken

This post is made possible by the generous support of people like you and our sponsors:
  Parts Connexion  

Follow Ups Full Thread
Follow Ups
  • RE: biasing setup on Scott 222D question - Michael Samra 11:28:33 03/19/17 (0)


Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.