Thanks again for your suggestion to replace the capacitors in the crossover, but I,do have a couple questions. My electronics knowledge needs some assistance, but I have searched the archives until I am blue in the face.
The original capacitors in the crossover are polarized, axial, electrolytics according to the schematic and pictures. Is it okay to replace this type with a metallized polypropylene capacitor of the same value that is not polarized?
Is your preference for the Dayton metallized poly caps because they may not change the high frequency presentation?
I do not plan to change the coils, but I thought the grille change may be a good idea. That crosspiece in the middle of the original grille may interfere with the tweeter, as may the grille fabric.
This post is made possible by the generous support of people like you and our sponsors:
Topic - Pinging Coner about Hitachi HS-500 speaker. - alaskahiatt 18:25:28 01/28/17 (12)
- I'd try out adding a small amount of R in parallel with the new capacitor as its equivalent series resistance - Timbo in Oz 16:18:42 02/05/17 (3)
- Your post is over my head. Here is the crossover schematic. - alaskahiatt 19:48:45 02/05/17 (2)
- okay, you seem to have a 4-position switchable level control on the treble. - Timbo in Oz 20:25:52 02/05/17 (1)
- Thanks for the response. Yes, they are wirewound resistors. nt - alaskahiatt 21:30:56 02/05/17 (0)
- RE: Pinging Coner about Hitachi HS-500 speaker. - Coner 18:30:45 01/29/17 (3)
- Well, the archives did mention that going from an electrolytic cap - alaskahiatt 22:34:49 01/29/17 (2)
- RE: Well, the archives did mention that going from an electrolytic cap - Coner 01:15:24 01/30/17 (1)
- Here's the modification link in Japanese. I found that using babelfish.com - alaskahiatt 10:45:05 01/30/17 (0)
- Don't mean to hi-jack this thread... - Mr. Dick Hertz 19:33:03 01/28/17 (3)
- Thanks a lot. I assume that bipolar is the same as nonpolar, at least - alaskahiatt 22:20:21 01/28/17 (2)
- crossover capacitors. - Mr. Dick Hertz 09:30:20 01/29/17 (1)
- Thanks. That was my guess. nt - alaskahiatt 09:49:13 01/29/17 (0)