Vintage Asylum Classic gear from yesteryear; vintage audio standing the test of time.

---

[ Follow Ups ] [ Post Followup ] Thread: [ Display  All  Email ] [ Vintage Asylum ]

---

[ Alert Moderator ]

---

Re: bold eagle/kudos & a question

Posted by Bold Eagle (A) on May 6, 2007 at 15:35:24

In Reply to: bold eagle/kudos & a question posted by pappy 1st on May 5, 2007 at 19:42:41:

I wouldn't expect a preamp/power amp mismatch would have that siginificant an effect. Almost sounds like an out of phase situation. Does the Hafler have a bridging switch?

The easiest way to check for channel phase is to hook a speaker across the + terminals and feed the amp the same source to both channels (as with a Y connector). If the channels are in phase, there will be little or no output from the speaker. Or you can just reconnect everything and try reversing the phase in one channel.

Jerry

This post is made possible by the generous support of people like you and our sponsors:

The Cable Cooker

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2024, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---