|
Vintage Asylum Classic gear from yesteryear; vintage audio standing the test of time. |
|
|
|
Vintage Asylum Classic gear from yesteryear; vintage audio standing the test of time. |
|
In Reply to: no preamp at all. posted by zman on February 16, 2007 at 17:47:12:
Zman makes an important point that amps with a sensitivity below 2 VRMS for full power don't need a line stage with gain.A passive control center can work well IF short, LOW capacitance, cables are used to connect it to the power amp. Passive control centers are inherently high impedance and are VULNERABLE to high frequency roll off.
I prefer a buffered level control, as it deals with both the gain and drive issues. For those using only a CDP for signal source, the DECWARE ZSLA-1 is an affordable option.
Eli D.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: no preamp at all. - Eli Duttman 05:00:47 02/17/07 (1)
- Calculate the HF rolloff - E-Stat 07:51:52 02/17/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
