[
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2007, Audio Asylum, all rights reserved ]
[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]
68.7.216.152
This Post Has Been Edited by the Author
In Reply to: RE: Pic ... and a question ... posted by Quadzilla on November 22, 2007 at 12:16:47
A short of DexOit on this panel may cure the problem, specially if there's a ribbon connector involved. Cold solder joints on the PCB containing the LEDs is also a possibility.
It's a good idea to spray DeOxit liberally on controls and other connections. Be careful with the front end variable capacitor though. Spraying it with DeOxit may cause temporary misalignment until the liquid dries.
Good luck with the unit!
Follow Ups:
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2007, Audio Asylum, all rights reserved ]