Home Tube DIY Asylum

Do It Yourself (DIY) paradise for tube and SET project builders.

Re: Do I have bad pot?

211.0.155.61

It may be ground soldering problem or ground loop problem. If the noise level would be affected by the pot rotation angle, it might show that buzz would be canceled or not canceled by the dividing ratio of the pot, The pot works as if a hum balancer.

Confirm signal ground wiring between the RCA jack to the pot. It should be connected to the chasis near the RCA jack at a point. (The minus side of RCA jack should not be touched to the chasis directly.)


This post is made possible by the generous support of people like you and our sponsors:
  Sonic Craft  


Follow Ups Full Thread
Follow Ups


You can not post to an archived thread.