Home Tube DIY Asylum

Do It Yourself (DIY) paradise for tube and SET project builders.

Re: Durn it... -> CCS?

The rule of thumb I've been using on the output stage is... Set the voltage on the pentode CCS equal to the plate-cathode voltage of the output tube. This gives you the compliance you need plus some margin.

On my 45 amp I have 180V across the cathode resistor to setup DC coupling, 275 Plate to Cathode on the 45, 275 across the 6bq5 pentode CCS.

Have fun!

Gary


This post is made possible by the generous support of people like you and our sponsors:
  Sonic Craft  


Follow Ups Full Thread
Follow Ups
  • Re: Durn it... -> CCS? - Gary P 08:40:18 10/30/01 (1)


You can not post to an archived thread.