|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: That is where the rot creeps in posted by PakProtector on June 15, 2021 at 17:32:04:
"I see plenty wrong with it. It comes down to there being no difference in reaction if the grids are driven balanced or if one side is fed no signal. The output is different in magnitude, as expected since the input is also different."
I'm not sure I understand what you are saying. Crowhurst presents a specific set of calculations which (apart from the error he made!) provide a formula for the required ratio of anode load resistors in order to achieve a balanced output. If you think his analysis is incorrect, can you provide an alternative derivation of an expression for the ratio RL1/RL2 of anode resistors that will produce a balanced output? What is your formula?
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: That is where the rot creeps in - cpotl 18:09:40 06/15/21 (1)
- RE: That is where the rot creeps in - PakProtector 03:36:15 06/16/21 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
