Question concerns the phono stage of a ARC-SP16. To start off, I should mention everything sounds great. I have been converting a few LPs to digital using Audacity. When I looking at the monitoring meter but not actually recording that there is "jittery noise" on the left channel but not on the right. If I touch the 1 uF cap on the plate of V1 (left channel), the jitter goes away but the baseline noise jumps up. The same happens when I touch the 1 uF cap on the right channel sans jitter. Did some tube swaps, etc. without any change.
Attached is the schematic of the phono stage and screenshot of Audacity. Any ideas?
"Our head is round in order to allow our thoughts to change direction." Francis Picabia
Edits: 04/25/21
This post is made possible by the generous support of people like you and our sponsors:
Topic - Noise on preamp - neolith 08:38:36 04/25/21 (12)
- A simple check - cellailuca 09:26:06 04/26/21 (2)
- RE: A simple check - neolith 13:37:06 04/27/21 (1)
- RE: A simple check - rivervalley817 14:20:54 04/27/21 (0)
- RE: Noise on preamp - Jonesy 12:07:34 04/25/21 (5)
- RE: Noise on preamp - sony6060 23:42:55 04/25/21 (4)
- RE: Noise on preamp - Stephen R 01:11:40 04/26/21 (3)
- RE: Noise on preamp - sony6060 01:19:22 04/26/21 (2)
- RE: Noise on preamp - Stephen R 03:48:14 04/26/21 (1)
- RE: Noise on preamp - sony6060 07:52:02 04/26/21 (0)
- RE: Noise on preamp - Stephen R 12:04:04 04/25/21 (0)
- RE: Noise on preamp - Triode_Kingdom 09:56:15 04/25/21 (1)
- RE: Noise on preamp - neolith 11:02:59 04/25/21 (0)