|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: Mu stage question... posted by Tre' on April 3, 2021 at 14:53:47:
However, it is too small to work other than to improve the measurements to 20khz. I would leave it out.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Yeah, in the guitar amp world that is a "bright" cap - Chip647 16:09:39 04/03/21 (9)
- So should I take it OUT and leave the bottom tube without.... - Ivan303 05:54:17 04/05/21 (7)
- RE: So should I take it OUT and leave the bottom tube without.... - Triode_Kingdom 09:22:55 04/05/21 (6)
- And this one? - Ivan303 10:17:51 04/05/21 (5)
- RE: And this one? - Triode_Kingdom 12:06:17 04/05/21 (3)
- Output doesn't need to swing much as the 300B is driving 106dB horns...s - Ivan303 12:24:48 04/05/21 (2)
- RE: Output doesn't need to swing much as the 300B is driving 106dB horns...s - Triode_Kingdom 14:23:56 04/05/21 (1)
- Thanks.... Done! - Ivan303 14:49:09 04/05/21 (0)
- See Morgan Jones - cellailuca 10:41:56 04/05/21 (0)
- RE: Yeah, in the guitar amp world that is a "bright" cap - Ivan303 18:46:58 04/03/21 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
