76.90.36.216
This Post Has Been Edited by the Author
In Reply to: RE: update 2 posted by deafbykhorns on February 20, 2019 at 15:15:55
I would say you want to adjust the level to where the amp is just below visible clipping.
Turn up the volume until you see the sine wave start to flatten (clip) at it's peaks then turn down the volume just a little until the sine wave is not flattening at its peaks and read the voltage.
If clipping is visible on a scope, the distortion is quite high. That's not usable power.
Tre'
Have Fun and Enjoy the Music
"Still Working the Problem"
Follow Ups:
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2019, Audio Asylum, all rights reserved ]
[ Take5 ]