Maybe one of these days I will learn to quit while I am ahead. It may not have been as pretty, but it was working fine and had no hum at all. Since making the changes it now has low level hum and the filaments of the 813's are not glowing evenly. I think they were before. Now the right side is brighter.
I had to compromise on the changes because it would have been just too much disassembly required to make all the changes that would put all the wires going to the plate connections on top of the 813 tubes inside the chassis
. It looks better now, but I now have hum and the 813 filaments on the right channel are glowing brighter than those on the left channel. They were all about even before I think. Anyway, it still sounds good, but now I will have to flush out the gremlins.
