|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: I got it! use the EICO HF86 scheme with 6c4 tubes posted by Eli Duttman on August 14, 2017 at 20:33:35:
My memory was that it was a 9 pin base, but that proved wrong. I checked the holes and like you said i would have to fabricate the plates to hold the smaller tube socket. Too bad.
I am thinking of just using 1/2 of an au7 of the tube per channel. I got lots of them so no big woof. I got the power supply sorted so almost half way to the finish line. As appearances go, i have the chassis painted light blue hammertone and the trannys are painted black. thanks for the suggestions. Dak
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Yeah, i found that out quick! - DAK 22:52:33 08/14/17 (2)
- RE: Yeah, i found that out quick! - Eli Duttman 02:28:35 08/15/17 (1)
- RE: Yeah, i found that out quick! - DAK 10:58:18 08/15/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
