In Reply to: RE: Filament bias posted by vetmedrobert@gmail.com on August 6, 2017 at 16:12:15:
Ale probably referred the bias to the negative end of the DC filaments. That's why they exactly fit your application. But in any case, never expect every tube to behave exactly the same as the plate curves in the data sheet are only typical and tubes can vary considerably from sample to sample even when new.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Filament bias - Thomas Mayer 23:55:26 08/06/17 (0)