|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: update on web search posted by vinnie2 on July 9, 2017 at 18:31:09:
I'm suggesting you parallel a 25-50 ohm resistor across the output of each of your amps. When the speaker is connected to the amp it sees ~ 6-7 ohms assuming 8 ohm speakers. When you disconnect the speaker the amp will see 25-50 ohms depending on the resistor value you choose to use. Most amps should tolerate both 6-7 ohms and 25-50 ohms across 8 ohm taps with signal applied w/o issue.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: update on web search - Steve O 18:45:41 07/09/17 (1)
- RE: update on web search - vinnie2 04:32:51 07/10/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]