In Reply to: RE: non-inverting preamp with emitter follower ... posted by Tre' on June 28, 2017 at 20:12:17:
Bottlehead recommended using isolation resistors when adding a subwoofer output on the ver. 1 Foreplay preamp, a basic cathode follower.
Not sure if I can lower the value of these resistors in my application.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: non-inverting preamp with emitter follower ... - deathtube 667 03:22:55 06/29/17 (10)
- RE: non-inverting preamp with emitter follower ... - Tre' 07:06:59 06/29/17 (9)
- RE: application ... - deathtube 667 10:51:42 06/29/17 (7)
- RE: application ... - Tre' 19:34:39 06/29/17 (6)
- RE: application ... - PakProtector 05:30:59 06/30/17 (5)
- RE: the idea is borrowed from BH Foreplay ver.1 ... - deathtube 667 06:46:37 06/30/17 (4)
- RE: the idea is borrowed from BH Foreplay ver.1 ... - Tre' 07:20:59 06/30/17 (3)
- RE: isolation resistors ... - deathtube 667 08:59:59 06/30/17 (2)
- RE: isolation resistors ... - Tre' 09:18:06 06/30/17 (1)
- RE: tried 100 ohm iso resistors ... - deathtube 667 06:10:59 07/06/17 (0)
- RE: non-inverting preamp with emitter follower ... - PakProtector 07:51:15 06/29/17 (0)