I was playing around with this non-inverting cathode follower preamp in LTSpice.
At lower Hz's, the Z out seems to have a bit of a slope going up to 3.6K ohms @ 20Hz.
Raising up the output cap value from 2.2u to 47uf seems to flatten out the Z curve at lower frequencies a lot, but doesn't seem to influence gain or THD%.
Would it be OK to flatten out the Z curve with a bigger uF output cap or should I just keep to the schematic values?
dt 667
This post is made possible by the generous support of people like you and our sponsors:
Topic - TK's 6SN7 non-inverting cathode follower preamp: Z out ? - deathtube 667 11:11:06 06/06/17 (1)
- Line Stage Output Z - Triode_Kingdom 12:42:12 06/06/17 (0)