Home Tube DIY Asylum

Do It Yourself (DIY) paradise for tube and SET project builders.

RE: update.....

I think I see what you are saying...bring everything to the top of the resistor that will have the one wire going to the plate connector. I suppose that could work. I never looked at it before because I did not have the resistor hooked to the pin. I will have to look at it carefully to see how it will fit under the chassis, but it would be nice to have only the one wire going from the resistor to the plate connector on the outside. I just hope there is room to do it. Thanks for the tip.


This post is made possible by the generous support of people like you and our sponsors:
  Kimber Kable  


Follow Ups Full Thread
Follow Ups

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.