Home Tube DIY Asylum

Do It Yourself (DIY) paradise for tube and SET project builders.

RE: Correction

I see. I was going by the schematic, which shows the resistor between the OT and the plate.

I didn't notice the pic with all the extra wires connected up by the cap. All those should really be moved below deck.

As Tre mentioned, the resistor should be soldered as close as possible to the G2 pin. I presume the other wire coming off the caps of the driver tubes is going to the 0.1 coupling cap. That can be moved underneath too. Just connect it to the same place as the other end of the wire going to the cap and remove the wire. The result will be much cleaner looking and safer.


This post is made possible by the generous support of people like you and our sponsors:
  Take Five Audio  


Follow Ups Full Thread
Follow Ups
  • RE: Correction - FlaCharlie 09:37:37 05/31/17 (1)

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.