|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: voltage drop posted by vinnie2 on May 31, 2017 at 09:06:46:
The 200 ohm resistor (grid stop resistor) goes between the screen grid and the plate, with the resistor itself as close to the screen grid pin on the tube socket as you can get it.
You want the lead, from the resistor to the grid pin on the tube socket, as short as possible.
The length of the resistor lead from the resistor to the plate connector is not important.
The wire from the output transformer goes directly to the tube's plate connection.
Tre'
Have Fun and Enjoy the Music
"Still Working the Problem"
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: voltage drop - Tre' 09:18:47 05/31/17 (1)
- RE: voltage drop - vinnie2 09:25:36 05/31/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
