|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: Finally ........... it's done. posted by vinnie2 on May 31, 2017 at 09:05:29:
The wave form will "square off" at the top and at the bottom.
Increase the output of the tone generator until it clips then lower the output of the tone generator until you don't see any clipping.
Then measure the AC voltage across the 8 ohms resistor and do the math.
Tre'
Have Fun and Enjoy the Music
"Still Working the Problem"
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Finally ........... it's done. - Tre' 09:10:08 05/31/17 (1)
- RE: Finally ........... it's done. - vinnie2 03:53:48 06/01/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
