In Reply to: RE: First Bench Test posted by Triode_Kingdom on May 26, 2017 at 10:14:29:
Just to illustrate what I mean, the two diagrams below show the AC current paths in a cathode follower and a common cathode amplifier. Installing a CCS (or high-impedance choke) anywhere in either loop will prevent AC current from flowing through the respective load.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- AC Current Path (Diagrams) - Triode_Kingdom 23:26:52 05/26/17 (13)
- Thank you and one more question. - Tre' 07:53:30 05/27/17 (12)
- Mu Follower Current - Triode_Kingdom 11:15:07 05/27/17 (11)
- I'm starting to get a picture different than I thought it was - Tre' 19:49:45 05/27/17 (10)
- RE: I'm starting to get a picture different than I thought it was - Triode_Kingdom 01:36:20 05/28/17 (9)
- RE: I'm starting to get a picture different than I thought it was - Tre' 10:34:20 05/28/17 (6)
- Tubes and Solid State - Triode_Kingdom 12:01:55 05/28/17 (5)
- Point taken but.... - Tre' 13:02:23 05/28/17 (4)
- RE: Point taken but.... - PakProtector 04:59:16 05/29/17 (0)
- RE: Point taken but.... - Triode_Kingdom 14:02:34 05/28/17 (2)
- Thank you again. (nt) - Tre' 14:24:03 05/28/17 (1)
- You're welcome, it was helpful to me as well - Triode_Kingdom 15:55:13 05/28/17 (0)
- RE: I'm starting to get a picture different than I thought it was - Tre' 07:17:56 05/28/17 (1)
- RE: I'm starting to get a picture different than I thought it was - Triode_Kingdom 08:20:48 05/28/17 (0)