|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: is orange wire on electraprint choke for b+end? posted by cpotl on May 15, 2017 at 11:16:41:
now your confusing me ha ha. I just assumed electraprint would of had a preferred phase. I didn't think of adding phase into the search either. For the record pale blue is the outside and orange is on the inside of the core which is connected to the b+ where it can stay for now. volts are going to be low. I want to run them super conservatively unless they sound too dull. I usually assume the reder or orange to mean the higher voltage or b+ end
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: is orange wire on electraprint choke for b+end? - amnesiac 04:01:21 05/17/17 (2)
- RE: is orange wire on electraprint choke for b+end? - dave slagle 07:43:29 05/17/17 (1)
- RE: is orange wire on electraprint choke for b+end? - amnesiac 08:20:13 05/17/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
