|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Custom 6sn7 preamp runs too hot posted by Cuernavaca on May 12, 2017 at 10:36:09:
Since heat rises it would help to have some way for some of the heat to escape through the top plate.
It looks like there are two holes towards the sides that have a screw or bolt that are not really doing anything. As an experiment you could try to remove them to see if it helps.
It's a lovely looking piece of equipment but I would be tempted to drill some holes in inconspicuous places.
ray
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- holes in top plate - RayP 05:23:50 05/13/17 (2)
- Thanks everybody for the help. - Cuernavaca 09:04:31 05/13/17 (1)
- RE: Thanks everybody for the help. - GEO 18:35:34 05/14/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
