In Reply to: Vishay MKP caps posted by vetmedrobert@gmail.com on April 22, 2017 at 05:54:57:
If you clean the chassis and the glued side with acetone first. Using one of the "glue all" type adhesives works really well. I usually solder some 18 or 16 gauge solid wire across both contacts by bending the pin in a loop and crimping it tightly to the wire. You can solder it to make it permanent. Since i always use a ground bus i try to position the cap so that the grounding lead goes directly straight up to the bus wire thus helping to support it.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Glue worx - DAK 09:02:00 04/22/17 (1)
- silicone caulk (any color) with a clamp... no shipping clown will dislodge them from their position.~nT - Cleantimestream 17:12:13 04/22/17 (0)