|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: 6B4G Single End amp in a new suit ? posted by Triode_Kingdom on April 3, 2017 at 12:44:31:
Isn't the B+ across the 6B4g supposed to be 250vdc? Using a 10 ohm resistor drops the entire B+ across the tube and at 50ma,he is at full dissipation for that tube.If it was setup for fixed bias,he could control the current at least when using a 10 ohm cathode resistor.
"For every complex problem there is an answer that is clear, simple, and wrong" H. L. Mencken
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- There is one other thing. - Michael Samra 20:48:03 04/03/17 (2)
- A matter of choises - pix 23:10:10 04/03/17 (1)
- RE: A matter of choises - Michael Samra 03:45:31 04/04/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
