In Reply to: Filament supply with no center tap posted by banpuku on February 22, 2017 at 13:17:28:
Keep in mind those resistors are the B+ current path. How much plate current are you going to get with 50K to ground? (100K / 2).A low ohm pot with a suitable cathode resistor and bypass cap are needed.
P.S. if you can't stand a pot, the you need to hand select two filament resistors for lowest hum. That's going to be tough at those low values.
Edits: 02/22/17
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- 100K ? - gusser 13:27:26 02/22/17 (5)
- RE: 100K ? - banpuku 13:29:23 02/22/17 (4)
- RE: 100K ? - gusser 13:32:34 02/22/17 (3)
- RE: 100K ? - banpuku 13:34:52 02/22/17 (2)
- RE: 100K ? - gusser 13:46:17 02/22/17 (1)
- RE: 100K ? - Tre' 17:05:08 02/22/17 (0)