|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: One of the problems with this design posted by Ralph on February 10, 2017 at 11:35:33:
I have fully differential mono-block power amps where the 1st and 2nd stages are direct coupled. Voltage offset in the output of the 1st stage is avoided by the use of a CT plate choke and a reasonably balanced 6SN7 (necessary for the choke) for the first stage. Low DCR of the choke and small imbalance current take care of that.
"It is better to remain silent and thought a fool, then speak and remove all doubt." A. Lincoln
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: One of the problems with this design - JKT 12:58:32 02/10/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
