|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: Learning how to use psud2 posted by Tre' on February 5, 2017 at 17:44:43:
Hi tre, the 120s will be running at 110ma each. the drivers at 12ma . The 28 ohm is end to end. It is a big mofo.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Learning how to use psud2 - DAK 17:54:57 02/05/17 (18)
- RE: Learning how to use psud2 - Tre' 17:58:07 02/05/17 (17)
- RE: 12ma each nt - DAK 18:33:32 02/05/17 (0)
- I assumed 24ma. for the driver stages total. - Tre' 18:08:11 02/05/17 (15)
- How do you expand the graph to show the small increments? - DAK 18:43:57 02/05/17 (6)
- RE: How do you expand the graph to show the small increments? - Tre' 18:47:52 02/05/17 (5)
- RE:when i zoom in the graph goes off screen - DAK 18:55:53 02/05/17 (4)
- RE:when i zoom in the graph goes off screen - Tre' 18:57:17 02/05/17 (3)
- Ok i got to expand just the graph - DAK 19:10:34 02/05/17 (1)
- RE: Ok i got to expand just the graph - Tre' 19:20:42 02/05/17 (0)
- click the zoom buttons until you can see it all then click and drag. - Tre' 19:00:12 02/05/17 (0)
- There is a problem - Tre' 18:37:41 02/05/17 (6)
- RE: if i add ss rectifiers aka Graetz bridge.... - DAK 19:53:09 02/05/17 (4)
- RE: if i add ss rectifiers aka Graetz bridge.... - Tre' 20:07:30 02/05/17 (3)
- RE:what about a 5u4gb ? - DAK 21:21:17 02/05/17 (0)
- RE:what about a 5u4gb ? - DAK 21:12:23 02/05/17 (1)
- RE:what about a 5u4gb ? - Tre' 07:42:18 02/06/17 (0)
- I had to reduce C1 to 3.9uf to get within spec. - Tre' 18:45:53 02/05/17 (0)
- Ok, i am going to input the values and see if i can match u nt. - DAK 18:36:01 02/05/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
