I am trying to learn how to use the software and have not found a way to input this type of filter. I inputted my trans specs. Moved the pointer to change rectifier, 2x clicked to change to tube, selected 5ar4, then on select filter there is no choice for clclc. How do you input that? TIA, Dak
This post is made possible by the generous support of people like you and our sponsors:
Topic - PSUD2 how to input a CLCLC filter? - DAK 19:01:43 01/31/17 (9)
- RE: PSUD2 how to input a CLCLC filter? - BenM 19:40:40 01/31/17 (8)
- That worked good but my sim won't run - DAK 00:26:03 02/01/17 (6)
- RE: That worked good but my sim won't run - Tre' 03:42:49 02/01/17 (5)
- RE: How do you determine "LOAD" nt. - DAK 11:28:22 02/01/17 (3)
- RE: How do you determine "LOAD" nt. - BenM 14:43:08 02/01/17 (0)
- RE: How do you determine "LOAD" nt. - Tre' 12:02:40 02/01/17 (1)
- All right. gracias! nt - DAK 15:06:47 02/01/17 (0)
- RE: That worked good but my sim won't run - Tre' 08:39:26 02/01/17 (0)
- Thank you i shall give it a go nt - DAK 23:29:06 01/31/17 (0)