|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: lundahl par-pp output transformers your thoughts? posted by used-hifi on January 21, 2017 at 10:08:08:
Lundahl uses a transformer geometry where windings are separated from each other on different sides of the core. That may work well for push pull but not single ended because the spacing causes a phase loop-d-loop in the 10-20Khz range. For SE an EI core is a better configuration since the windings are on top of each other and the phase issues are above the audible range.
Yes, this statement will cause a controversy.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: lundahl par-pp output transformers your thoughts? - Scholl 14:34:31 01/21/17 (2)
- RE: lundahl par-pp output transformers your thoughts? - Scholl 03:49:48 01/22/17 (0)
- RE: lundahl par-pp output transformers your thoughts? - used-hifi 14:52:38 01/21/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
