|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: Fixed bias problem, and no, it is not the tubes. posted by Acoustic-Dimension on January 12, 2017 at 00:50:04:
And it slowly declined after about 5 minutes. The coupling caps are 2 brand new Mundorf Silver and Gold in oil. The voltage rating on those are 800vdc so i seriously doubt that it is defective. The 10R resistor is a 2 watt unit and i did check it at the same time and it was not even warm, so again, doesnt appear to be a problem.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- I monitored the bias voltage over time - DAK 02:25:27 01/12/17 (5)
- RE: I monitored the bias voltage over time And it slowly declined after about 5 minutes. - Chip647 04:45:31 01/12/17 (0)
- RE: I monitored the bias voltage over time - Acoustic-Dimension 02:30:19 01/12/17 (3)
- RE: I monitored the bias voltage over time - DAK 09:35:23 01/12/17 (0)
- RE: I monitored the bias voltage over time - Uncle Mike 03:23:31 01/12/17 (1)
- RE: I monitored the bias voltage over time - Acoustic-Dimension 04:28:00 01/12/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
