In Reply to: RE: stop monkeying with psud2 hoooey, its never right posted by vinnie2 on January 4, 2017 at 14:48:00:
Start with something simple. Stick a voltage source on the page and ground the bottom. Then wire two series resistors across it. Tell the software to RUN. When it's done, look at the voltage and current around the circuit. It's a small step from there to viewing RC time constants, LC filters, power supplies, tube amplifiers etc. Not for everyone, I know, but it's an extremely useful tool.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: stop monkeying with psud2 hoooey, its never right - Triode_Kingdom 18:55:54 01/04/17 (1)
- RE: stop monkeying with psud2 hoooey, its never right - vinnie2 02:57:22 01/05/17 (0)