|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Maybe no bypass? posted by 91derlust on July 6, 2015 at 13:06:51:
High gain ? Use a lower value load and you'll get lower Rout and lower gain from the driver . Why not place the cathode circuit and G2 of the 6C6 within the cathode circuit of your output valve ? You may only need a single bypass cap between output stage cathode and 0V as you'll be running tens of milliamps through the cathode bias stack . I have only tried this with a triode connected D3A but it should in theory work with a pentode . The 'full monkey' used a similar scheme if I remember correctly
Al
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Maybe no bypass? - Al Noakes 14:48:24 07/06/15 (2)
- RE: Maybe no bypass? - 91derlust 19:06:41 07/06/15 (1)
- RE: Maybe no bypass? - Al Noakes 22:36:01 07/06/15 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]