In Reply to: RE: Chassis Source other than Hammond or Par Metal. posted by amandarae on January 24, 2013 at 15:00:02:
If you are talking about all these side/front extrusions, then no you can't connect four together. You need to screw on front/back plates into the holes provided in the extrusions. Then you add top and bottom plates. With the Penn-Elcom extrusions you can slide in a fairly thin top plate - I'd estimate about 1-2mm. Otherwise you screw the top plate on. I do that since I use 4mm top plates.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Chassis Source other than Hammond or Par Metal. - andy evans 03:04:12 01/25/13 (0)