|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Thanks Luca! What brand of toroids do you use as output trannys? posted by grhughes on July 2, 2012 at 11:27:05:
I would rather recommend a 2X115V - 2X9V tranny like this
http://it.rs-online.com/web/p/trasformatori-di-toroide/6719075/
The 2X12V output model I think is good too (but an higher plate resistance should also get a lower distortion).
You might wish a 50VA model as an alternative to the 30 VA model, but I do not think there will be any practical difference with the intended (5687) tube.
The extra 9V output winding can be used for NFB or wired in parallel.
Best Regards
Luca
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Thanks Luca! What brand of toroids do you use as output trannys? - 6AS7_6SN7 05:11:33 07/03/12 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]