In Reply to: I'm no expert but although it's at the low end I think it will do posted by Naz on May 28, 2012 at 16:28:21:
...watch those feed rates however. Carbide is brittle amd if it doesn't like your speed and feed it will snap instantly with pieces flying who knows where. Obviously, wear goggles.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- I've used 8,000 RPM with carbide PC drills and it works just fine for low volume projects... - Steve O 19:37:52 05/28/12 (0)