In Reply to: High speed drilling is used in PCB manufacturing plants posted by Naz on May 28, 2012 at 15:53:07:
nt
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Thanks! Is 8500RPM too slow for carbide bits? nt - grhughes 16:13:55 05/28/12 (2)
- I'm no expert but although it's at the low end I think it will do - Naz 16:28:21 05/28/12 (1)
- I've used 8,000 RPM with carbide PC drills and it works just fine for low volume projects... - Steve O 19:37:52 05/28/12 (0)