I am building my first LCL filament supply for a DHT tube.
Due to the tube I am using I will need to use a dropping resistor
to get the voltage down to spec.
My question is, where is the best place to put the resistor?
Before the LCL after the LCL or somewhere inside the LCL?
Thanks, Cal
This post is made possible by the generous support of people like you and our sponsors:
Topic - Where do I put it? - thermionic addictions 11:21:49 04/24/12 (16)
- Thanks guys, some intresting ideas here. Another question. - thermionic addictions 09:17:07 04/25/12 (4)
- this may be your answer - bouncy ball 22:36:23 04/25/12 (0)
- A multi-winding filament transformer - grhughes 11:52:40 04/25/12 (0)
- Potentiometer, no. VARIAC you betcha. - Chris O 11:35:32 04/25/12 (1)
- RE: Potentiometer, no. VARIAC you betcha. - thermionic addictions 12:57:35 04/25/12 (0)
- RE: Where do I put it? - wheezer 08:52:09 04/25/12 (0)
- RE: Where do I put it? - dave slagle 18:25:45 04/24/12 (3)
- RE: Where do I put it? - Naz 19:29:58 04/24/12 (2)
- RE: Where do I put it? - dave slagle 05:17:27 04/25/12 (0)
- RE: Where do I put it? - GTCharlie 04:16:18 04/25/12 (0)
- RE: Where do I put it? - Stuben 15:14:02 04/24/12 (2)
- He was talking about a filament supply ,,, - Naz 15:24:28 04/24/12 (1)
- RE: He was talking about a filament supply ,,, - Stuben 07:47:13 05/04/12 (0)
- Have you considered diodes or PTC? - Naz 15:03:59 04/24/12 (0)
- RE: Where do I put it? LCL (RC) - Chris O 11:27:17 04/24/12 (1)
- RE: Where do I put it? LCL (RC) - thermionic addictions 13:44:43 04/24/12 (0)