|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: another pic posted by frankford on March 5, 2012 at 17:22:57:
It looks to me like the tube in the back has it's 0.68ohm resistor being fed from the 0.68ohm resistor on the first tube. Both 0.68ohm resistors should be fed from the blue wire which I assume comes from the transformer. So move that red wire from the front tube socket to the terminal strip where the front 0.68ohm is tieed to.
That said it should still work they way you have it, one tube however will have less heater power.
Did you test the 0.68ohm resistors?
The soldering of the two blue wires and the terminal strip could use some cleanup. It looks like a short waiting to happen.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: another pic - gusser 18:25:01 03/05/12 (1)
- Flux Removal - gusser 13:35:59 03/06/12 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
