Home Tube DIY Asylum

Do It Yourself (DIY) paradise for tube and SET project builders.

RE: OK....

So, I hooked up the heaters using the 7 vac per pictures from the building manual. I only got 3.3 acv with the tubes installed, 7.2 vac with them out. I measured the resistance across both tubes and they showed 1.1 ohms. I measured a second pair of 6550's from a VTL amp and they showed the same.

I went back and wired the heaters per schematic, high side to .68 ohms to pin 7 of one tube. I wired from pin 7 to other .68 ohm and left the resister to pin 2 of other 6550. I and ran a extra ground from the low side connecting pins 7 and 2. The ground was ran to the star ground that is on the power supply board. I had 8 ohm resisters on the opt terminals.

I decided to hook it back up to the speakers and run my ipod into it. It started up no problems but after a few minutes the left side died down and the right side died down a little bit. I decided to turn it off and go back in, I just start sweating so fast when I have it open and powered up. Thanks guys I think I am making progress.


This post is made possible by the generous support of people like you and our sponsors:
  Sonic Craft  


Follow Ups Full Thread
Follow Ups

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.