In Reply to: RE: Are you sure ... posted by casouza on May 6, 2009 at 19:27:31:
I've repaired some of these that actually damaged the boards, too. Seems the set nut comes loose and when the pot shaft is hit, the force transfers to the board. I try to use two nuts. One on the inside tighten up against one on the outside of the chassis. Helps keep the shaft from getting loose due to vibration from the amp.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- PCB mounted pots - FenderLover 00:53:48 05/07/09 (1)
- RE: PCB mounted pots - bdgregory 08:07:10 05/07/09 (0)