I have heard many posters saying that
lower power operating points sound better
than the "max" operating points.
I was wondering if that had to do with:
1) lower B+ - keeping away from max voltage
2) lower current - lower max dissipation
3) higher Z OPT - flatter load line
Or some combination of the above ?
I am thinking of the 300B for me.
But I have heard that about other tubes as well.
I have not heard this discussed before
and always wondered about it.DanL
This post is made possible by the generous support of people like you and our sponsors:
Topic - Low vs High Operating Points - danlaudionut 03:45:27 05/08/07 (24)
- False dichotomy? - rdf 21:15:05 05/11/07 (1)
- Re: False dichotomy? - danlaudionut 23:49:38 05/11/07 (0)
- Mr Danlaudionut: I think it would be interesting to try two points:LoV/HiA, HiV LoA - -3db 19:34:13 05/09/07 (2)
- You give me way too much credit - danlaudionut 21:18:41 05/09/07 (1)
- Re: You give me way too much credit - drlowmu 07:40:28 05/10/07 (0)
- Low Vp@ High Ip - Ian L 22:35:59 05/08/07 (0)
- Re: Low vs High Operating Points - kurt s 19:48:59 05/08/07 (0)
- Re: Low vs High Operating Points - richardl 17:45:42 05/08/07 (3)
- Re: Low vs High Operating Points - danlaudionut 17:52:11 05/08/07 (2)
- Re: Low vs High Operating Points - richardl 14:09:14 05/10/07 (1)
- Re: Low vs High Operating Points - danlaudionut 17:42:30 05/11/07 (0)
- Actually there's been a lot of debate on this subject ... - Naz 05:26:03 05/08/07 (3)
- Re: Actually there's been a lot of debate on this subject ... - danlaudionut 06:12:52 05/08/07 (2)
- Re: Actually there's been a lot of debate on this subject ... - drlowmu 06:45:53 05/08/07 (1)
- Re: Actually there's been a lot of debate on this subject ... - danlaudionut 09:04:55 05/08/07 (0)
- Load Lines - Chris O 05:00:23 05/08/07 (8)
- Re: Load Lines - andrewbee 06:47:12 05/08/07 (7)
- Re: Load Lines - danlaudionut 06:56:00 05/08/07 (6)
- Great Site Dan ... - Naz 16:01:08 05/08/07 (5)
- Re: Great Site Dan ... - danlaudionut 16:11:58 05/08/07 (4)
- Re: Great Site Dan ... - Naz 17:30:20 05/08/07 (3)
- Re: Great Site Dan ... - danlaudionut 17:48:45 05/08/07 (2)
- Re: Great Site Dan ... - Naz 19:42:37 05/08/07 (1)
- Re: Great Site Dan ... - danlaudionut 06:39:18 05/09/07 (0)