|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: how to set output current on G Pimm's CCS circuit? posted by jarthel on April 23, 2007 at 18:36:11:
The - terminal goes to the anode of the loaded tube. You must have a load. You can check the load across R1 but I would check the load across the cathode resistor of the loaded tube.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: how to set output current on G Pimm's CCS circuit? - snert 19:06:35 04/23/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
