|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: Re: message for Eli posted by Vinnie on April 20, 2007 at 17:45:37:
Yes, in this case the two can share a filament winding. Run the two in parallel. If your winding has a CT use it for the output to the first cap, if not use pin 8.BTW on the pic the first cap is 100uf. That strikes me as a bit large. I’d use 40uf …John
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: message for Eli - 2wo 18:29:25 04/20/07 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]