In Reply to: volume pot quite close to a tube - is this okay? posted by jarthel on April 18, 2007 at 07:36:11:
Hi.If you can't move the attenuator away from any tubes being so close,
add a reflecive aluminum foil shield over the entire attenuator areas. Make sure you ground the foil shield.It will serve two purposes:
(1) heat shield - to keep the resistors & selector contacts cool.
(2) noise shield - to shield out any noise emissions (RF/hum) from
the tubes.I always put reflective aluminum foil shield on filter can-caps which often sit so close to the hot hot rectifier tube & power tubes.
c-J
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Not OK to me unless you put on a heat shield. - cheap-Jack 08:55:43 04/19/07 (0)