Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders.

---

[ Follow Ups ] Thread: [ Display  All  Email ] [ Tube DIY Asylum ]

---

[ Alert Moderator ]

---

Build ideas for Allen Wright PP-1C Push Pull Power Amp

Posted by Burney (A) on April 15, 2007 at 06:39:37

I have been searching for simple but killer PP schematic and increasingly veering around to the Allen Wright PP1. Schematic linked below. I am a build-by-schematic guy but like to retain some flexibility. Some question before I start to build:

1. The overall gain is 20dB. Is it enough for a direct out from a CDP?
2. Will this design accept other power tubes? 6550, EL84, KT66?
3. What if I don’t like the ECC88? What about a 12AX7?
4. How about UL connection?
5. The Cathode bypass cap is a massive 8,000uf. Why? Is it ok to substitute with a lower value?
6. Can I use individual fixed bias for the output tubes? Is it going to mess up the performance?
7. Finally, if for some reasons I need to apply global NFB, how it should be done.

• http://www.vacuumstate.com/schematics/pp-1c_s.gif   (Open in New Window)

This post is made possible by the generous support of people like you and our sponsors:

Herbie's Audio Lab

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2024, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---