What should a person typically expect to see for resistance measurements on the pri and sec windings of a power tranny?
When using psud2, can you use the resistive load to help adjust the output voltage to what you need it to be? Could you then tap into the loop just above the resistor for your B+, and would it stay the same, or will it drop when you hook it up to the rest of the amp?
Are there other ways to lower the voltage a tad to get the B+ you what?
Thanks
Vince
This post is made possible by the generous support of people like you and our sponsors:
Topic - more psud2 questions - Vinnie 15:18:47 04/11/07 (2)
- Re: more psud2 questions - BofService 12:11:02 04/13/07 (0)
- Re: more psud2 questions - Tom Bavis 18:13:19 04/11/07 (0)